Buder water leak detectors provide you with “detects” and “protects”.
This unique device not only detects leaks but also shuts off flow to a drinking water system in the event a leak should occur.
This product is a small up-front investment and suitable for all kinds of POU Water Dispensers”, “ Water Coolers/Chillers ”, “ Drinking Water Boilers ”, “Drinking Water Fountains”, “Reverse Osmosis (RO) Systems”, “Water Purifiers”, “ Chilled Liquor Dispenser ”, “Water filters” etc…, designed to eliminate possible damage to homes and business property.
How it works!
The patented device is novel but quite simple. When a leak occurs, the adsorbent applicator “tablet” expands to close the valve and shut off the incoming water supply.
Product Functions:
- White plastic easy to install
- Water Leak Detector
- WLD 3/8″
| Step 1 | Turn off the water supply to the filtration system at the cold water source valve. |
| Step 2 | The water leak detector should be mounted flat in the lowest ground point near the filtration system so in the event a leak occurs the water will flow in the direction of the valve. |
| Step 3 | Clean the designated installation area with rubbing alcohol. |
| Step 4 | Peel the red backing tape from the two mounting feet on the base of the shut-off valve and press down firmly over the chosen install area. You may also mount the valve using the screws included in the kit. |
| Step 5 |
Cut the system’s water supply tube to splice in the valve. connect the tubing from the water source valve to the horizontal fitting on the shut-off valve labeled “in” by pushing the tubing in firmly until fully seated
|
| Step 6 | Connect the tubing leading from the filtration system to the vertical fitting on the shut-off valve labeled “out” by pushing the tubing in firmly until fully seated. |
| Step 7 | Turn on the water supply to the filtration unit and check for leaks. |
Maintenance Procedure
1. Suggest regular maintenance every six months in order to remove dirt and oil stains.
2. It is recommended to apply new silicone oil during maintenance, repeat operation.
3. Repeat around 20~30 times to make it work properly.
4. The leaking circuit breaker is recommended to be replaced after one year. New product, in order to keep the leaking circuit breaker operating normally.
